GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the back
of the unit. Use a coin or a screwdriver
to loosen the screw and open the battery
cover.
3. Remove old batteries by pulling up on
one side of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the battery box. (The use of new
alkaline batteries is recommended for maximum performance.)
5. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity ( + and - ).
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in re.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging
(if removable).
• Rechargeable batteries are only to be charged under adult
supervision.
DO NOT USE RECHARGEABLE BATTERIES.
4
533400 IM.indd 4 12/31/2019 14:38:49
To Next Page
Loading...
Need help?
General