7
GETTING STARTED
METHOD TO EXIT TRY-ME MODE:
Insert the vehicle into the Turbo Station Charge Pole to charge the
vehicle and enter travel mode. Alternatively, remove the batteries
from the Turbo Station and install a brand new set of batteries.
Then, turn the Turbo Station on again to enter normal play mode.
TURBO STATION:
BATTERY REMOVAL AND
INSTALLATION
1. Make sure the Turbo Station is turned OFF.
2. Locate the battery cover on the bottom of
the Turbo Station.
3. Use a screwdriver to loosen the screw
and open the battery cover.
4. If used or spent batteries are present, remove
these batteries from the Turbo Station by
pulling up on one end of each battery.
5. Install 2 new AAA (LR03/AM-4) batteries
into the battery box as illustrated. (The use
of new alkaline batteries is recommended
for maximum performance).
6. Replace the battery cover and tighten the screw to secure.
Note: If there is no response when the Turbo Station is on,
please insert new batteries and try again.
To Next Page
Loading...
Need help?
General