20
Appendix
Adding and registering a new headset
Option 3: Register a headset to a DECT cordless telephone base
1. Make sure the battery is properly installed in
the headset. The LED light on the headset
flashes slowly in red and blue to indicate the
headset is not registered.
2. Place the headset in the charger cradle and
allow it to charge for at least one hour before
beginning registration.
3. Remove the headset from the charger cradle.
4. On the telephone base of the cordless phone,
press and hold
/HANDSET LOCATOR,
FIND HANDSET or
FIND HS, until the
IN USE light turns on and the screen displays the
“Registering” message, and then release the button.
The
LED light flashes quickly in red and blue.
• If your telephone base do not have the
/HANDSET LOCATOR,
FIND HANDSET
or
FIND HS button:
Press and hold the HOLD button until the screen displays
Registering... Please wait, then release the button.
It takes about 60 seconds to complete the registration process.
Once the headset is registered, The
LED
light turns red when the
battery is low and being charged, or turns purple when the battery
is well charged, or turns blue when the battery is fully charged.
If the registration fails, you hear the voice prompt "Not registered"
when you press
the
ON/OFF button on the headset, and the
ON/OFF button light on the headset alternates slowly in red and
blue. Try the registration process again.
To Next Page
Loading...
Need help?
General
