Notes
Use only the battery supplied with this product.
If the parent unit will not be used for a long time, disconnect and remove the battery to prevent possible leakage
Replace the battery
To replace the battery, press down on the battery compartment cover and pull it out, then follow the steps above to
install the battery.
Connect the baby monitor
Notes
Use only the power adapters supplied with this product.
Make sure the baby monitor is not connected to the switch controlled electric outlet.
Connect the power adapters in a vertical or floor mount position only. The adapters’ prongs are not designed to
hold the weight of baby monitor, so do not connect them to any ceiling, under the-table, or cabinet outlets.
Otherwise, the adapters may not properly connect to the outlets.
Make sure the parent unit, the baby unit and the power adapter cords are out of reach of children.
Charge the parent unit battery
When you have connected and turned on the parent unit, the battery will be charged automatically.
Notes
Before using the baby monitor for the first time, charge the parent unit battery for 12 hours. When the parent
unit battery is fully charged, the battery icon becomes solid .
It takes longer to charge the battery when the parent unit is turned on. To shorten the charging time, turn the
parent unit off while charging.
The standby time varies depending on the sensitivity level you set, your actual use and the age of the battery.
(2) Power on or off the baby monitor
(1) Slide the ON/OFF switch to power on or off your baby unit.
To Next Page
Loading...
Need help?
General
