What’s in the box
Press VIEW to switch between the image of baby units and .
Press VIEW
Change different views - View
Change different views - Patrol
Press PATROL to alternately view the image from baby units and every 10 seconds.
10s
Change different views - Split
Press SPLIT to view the images from all baby units at once.
Dim mode
With dim mode preset to on, your parent unit display will dim after 10 minutes of inactivity to conserve energy.
10 min inactivity
Press any buttons
Once you power on your baby monitor, your parent unit displays image from baby unit , and the LINK LED
light turns on.
The ON/OFF LED light of baby unit turns on. As baby unit is not being viewed, its ON/OFF LED light flashes.
Status checkConnect and power on - Baby unit Install the battery Connect and power on - Parent unit
• The default volume of your parent unit
is level 4. If you experience high-pitched
screeching noise from your baby monitor
while positioning:
- Make sure your baby unit and parent unit
are more than 1 meter (3 feet) apart, OR
- Turn down the volume of your parent unit.
＜1m (3ft)
＞1m (3ft)
> 1m (3ft)
< 1m (3ft)
VM5271-2 baby monitor system
Baby’s room Living room
Go to www.vtechphones.com
to register your product for
enhanced warranty support
and latest VTech product news.
VM5271-2
Quick start guide
2s
> 1m (3ft)
• This baby monitoring system includes a special lens which is capable of optical zoom and requires
delicate treatment. Please avoid disassembling, dropping, or any other rough handling.
THIS SIDE UP
To Next Page
Need help?
General
