* Operating times vary depending on your actual use and the age of the battery.
** Handset is not charging or in use.
NOTES
Place the handset in the charger will bypass the set date and time, and voice guide.
For best performance, keep the handset in the charger when not in use.
The battery is fully charged after 16 hours of continuous charging.
If you place the handset in the charger without plugging in the battery, the screen displays NO BATTERY.
Check the battery level
After you have installed the battery, check the battery level on the handset screen.
Check for dial tone
Press HOME/FLASH. If you can hear a dial tone, the installation is successful.
If you do not hear a dial tone
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to digital service from a cable company
or a VoIP service provider, the telephone line may need to be rewired to allow all existing telephone jacks to
work. Contact your cable/VoIP service provider for more information.
If you do not hear a dial tone
To Next Page
Loading...
