• Press 1 if you want to screen home calls with telephone numbers that are not saved in your directory, allow
list or star name list; or
• Press 2 if you do not want to screen calls, and want to allow all incoming calls to get through.
NOTES
The screening feature of Smart call blocker is applicable to home calls only. All incoming cell calls will get
through and ring. If you want to block a cell call, add the number to the block list. See Block list section.
You can press CANCEL on the telephone base to quit the voice guide at any time.
After a power outage, the telephone base prompts you to set the date and time. After the date and time setting
is done or skipped, the telephone base will prompt if you want to set up Smart call blocker via voice guide.
Press MENU/SELECT to start the setup.
Set up Answering System through Voice Guide (Before use)
This feature assists you to do the basic setup of the answering system. You can follow the voice guide to record
your own announcement, set the number of rings and the message alert tone.
1. Press MENU/SELECT to start the voice guide for the answering system setup. You hear the voice prompt “
This voice guide will assist you with the basic setup of your answering system.”
2. Setup your answering system by inputting the designated numbers as instructed in the voice guide.
Alternate way to set up
This feature is an alternative way for you to do the basic setup of the answering system. You can follow the voice
guide to record your own announcement, set the number of rings and the message alert tone.
1. Press MENU/SELECT on the telephone base in idle mode.
2. Press ▼ CID or ▲ to scroll to Answering sys, and then press MENU/SELECT.
3. Press ▼ CID or ▲ to scroll to Voice guide, the press MENU/SELECT. You hear the voice prompt “This voice
guide will assist you with the basic setup of your answering system.”
4. Set up your answering system by inputting designated numbers as instructed in the voice guide.
NOTES
You can press CANCEL on the telephone base to quit the voice guide at any time.
After a power outage, the telephone base prompts you to set the date and time, and Smart call blocker. After
these settings are done or skipped, the telephone base then prompts if you want to set up the answering
system via voice guide. Press MENU/SELECT to start the setup.
Install
Mount the telephone base (optional)
To Next Page
Loading...
Need help?
General
