Add and register handset
When your handset is deregistered from the telephone base, follow the steps below to register it back to the
telephone base.
1. Before you begin registration, make sure the handset is out of the telephone base or charger and shows To
register HS… and … see manual.
2. Put the handset you wish to register on the telephone base cradle.
3. The telephone base shows Registering… Please wait, and the handset then shows Registering…. If the
registration is successful, the handset screen displays Registered and beeps. The handset is now registered
with the telephone base.
If registration fails, the system will automatically try to register again. If registration fails after the third try,
Registration failed appears on the handset screen. The handset shows To register HS… and …see manual, and
the telephone base returns to idle mode. This may take up to five minutes to occur. Please start again from Step
1.
NOTE
If your handset is new, make sure you charge it before attempting registration.
General product care
Taking care of your telephone
Your cordless telephone contains sophisticated electronic parts, so it must be treated with care.
Avoid rough treatment
Place the handset down gently. Save the original packing materials to protect your telephone if you ever need to
ship it.
Avoid water
Your telephone can be damaged if it gets wet. Do not use the handset outdoors in the rain, or handle it with wet
hands. Do not install the telephone base near a sink, bathtub or shower.
Electrical storms
Electrical storms can sometimes cause power surges harmful to electronic equipment. For your own safety, take
caution when using electrical appliances during storms.
Cleaning your telephone
Your telephone has a durable plastic casing that should retain its luster for many years. Clean it only with a dry
non-abrasive cloth. Do not use dampened cloth or cleaning solvents of any kind.
Technical specifications
To Next Page
Loading...
