VTech VS 113 - Page 59

unless you delete the device from the device list.
NOTE
When connecting a Bluetooth device to the device list, all connected devices will be temporarily disconnected until
the procedure is complete. It may take up to two minutes to reconnect.
Review the device list
1. Press MENU/SELECT on the telephone base in idle mode to enter the main menu.
2. Press q CID or ▼ to highlight Bluetooth, then press
MENU/SELECT.
3. Press MENU/SELECT again to select Device list.
Connect/disconnect an active device
While in the device list menu, you may connect or disconnect your active device.
1. Press MENU/SELECT on the telephone base in idle mode to enter the main menu.
2. Press ▼ CID or ▲ to highlight Bluetooth, then press MENU/SELECT.
3. Press ▼ CID or ▲ to highlight Device list, then press MENU/SELECT.
4. Press ▼ CID or ▲ to highlight a device, then press MENU/SELECT.
5. Press ▼ CID or ▲ to highlight Connect/Disconnect (whichever is applicable), then press
MENU/SELECT. The telephone base displays Device connected/Device disconnected. You hear a confirmation
tone.
NOTE
When your active device is connected, you are prompted to select Disconnect. When your active device is
disconnected, you are prompted to select Connect.
Remove a paired device
When you already have 2 devices on the device list and you want to add another device, you must first delete one
from the list. You can only pair 2 cell phones or one cell phone and one Bluetooth headset.
To remove a paired device:
1. Press MENU/SELECT on the telephone base in idle mode to enter the main menu.
2. Press ▼ CID or ▲ to highlight Bluetooth, then press
MENU/SELECT.
3. Press ▼ CID or ▲ to highlight Device list, then press
MENU/SELECT.
4. Press ▼ CID or ▲ to highlight the desired device, then press
X/DELETE.
-OR-
• Press ▼ CID or ▲ to highlight the desired device, then press MENU/SELECT.
• Press ▼ CID or ▲ to highlight Remove, then press MENU/SELECT.