corrected. Replacement to this telephone equipment can only be made by the manufacturer or its authorized
agents. For replacement procedures, follow the instructions outlined under the “Limited warranty”.
If this equipment is causing harm to the telephone network, the telephone service provider may temporarily
discontinue your telephone service. The telephone service provider is required to notify you before interrupting
service. If advance notice is not practical, you will be notified as soon as possible. You will be given the opportunity
to correct the problem and the telephone service provider is required to inform you of your right to file a complaint
with the FCC. Your telephone service provider may make changes in its facilities, equipment, operation, or
procedures that could affect the proper functioning of this product. The telephone service provider is required to
notify you if such changes are planned.
If this product is equipped with a corded or cordless handset, it is hearing aid compatible. If this product has
memory dialing locations, you may choose to store emergency telephone numbers (e.g., police, fire, medical) in
these locations. If you do store or test emergency numbers, please: Remain on the line and briefly explain the
reason for the call before hanging up. Perform such activities in off-peak hours, such as early morning or late
evening.
Industry Canada
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the
device.
Privacy of communications may not be ensured when using this telephone.
The term ‘’IC:‘’ before the certification/registration number only signifies that the Industry Canada technical
specifications were met.
The Ringer Equivalence Number (REN) for this terminal equipment is 1.0. The REN indicates the maximum
number of devices allowed to be connected to a telephone interface. The termination on an interface may consist
of any combination of devices subject only to the requirement that the sum of the RENs of all the devices not
exceed five.
This product meets the applicable Innovation, Science and Economic Development Canada technical
specifications.
California Energy Commission battery charging testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the box. These instructions
are intended for California Energy Commission (CEC) compliance testing only. When the CEC battery charging
testing mode is activated, all telephone functions, except battery charging, will be disabled.
To activate the CEC battery charging testing mode:
To Next Page
Loading...
Need help?
General
