digits.
5. Press MENU/SELECT to save.
• The screen returns to the previous menu.
• You hear a confirmation tone.
NOTE
If, in the future, your telephone service provider requires you to dial the area code when making a local call, -
OR-, if you move to a location that requires it, delete the home area code you have already programmed,
following the steps above. After you have deleted the home area code, _ _ _ will appear on the display.
Ringer
Set number of rings
You can set the answering system to answer an incoming call after two, three, four, five or six rings; or toll saver.
If you choose toll saver, the answering system answers a call after two rings when you have new messages, or
after four rings when you have no new messages. This enables you to check for new messages and avoid paying
unnecessary long distance charges if you are calling from outside your local area. By default, the answering
system answers an incoming call after three rings.
Using a cordless handset or telephone base:
1. Press MENU/SELECT when the phone is not in use.
2. Press ▼ CID or ▲ to choose Answering sys, and then press MENU/SELECT.
3. Press ▼ CID or ▲ to choose Ans sys setup, and then press MENU/SELECT.
4. Press ▼ CID or ▲ to highlight # of rings, then press MENU/SELECT.
5. Press ▼ CID or ▲ to choose from 6, 5, 4, 3, 2 or Toll saver.
• Toll saver – the answering system answers a call after two rings when you have new messages, or after four
rings when there is no new message. This feature allows you to check for new messages and avoid paying
long distance charges when calling from out of your local area.
6. Press MENU/SELECT to save.
Set ringer tone
You can select the ringer tones for incoming home and cell calls.
Using a cordless handset or telephone base:
To set the ringer tone on home line:
1. Press MENU/SELECT in idle mode.
2. Press ▼ CID or ▲ to highlight Ringers, then press MENU/SELECT.
3. Press ▼ CID or ▲ to select Home ringtone, then press MENU/SELECT.
4. Press ▼ CID or ▲ to sample each ring tone for home line.
5. Press MENU/SELECT to save.
To set the ringer tone on cell lines:
To Next Page
Loading...
