To Next Page
M
Matthew ClarkAug 8, 2025
What to do if VWR Laboratory Equipment temperature does not reach set temperature?
- CChristopher ParrishAug 8, 2025
If the VWR Laboratory Equipment's momentary temperature doesn't reach the set temperature within 2 hours, it might be because the door isn't securely closed, you're opening it too often, or the room temperature is too low. Make sure the door is closed properly, reduce how often you open it during operation, and ensure the room temperature is above the minimum. After checking these, turn the power off and on, and try again. If the issue persists, there may be a thermal fuse cutoff, heater fault, electronic board fault or incorrect setting of parameters, so contact your distributor.
General
