Wabtec Ricon K1200 - User Manual

Questions and Answers

A
Ashley SalazarAug 10, 2025
What to do if my Wabtec Ricon K1200 Lifting Systems lift functions with abnormal operation?
- C
  Christina JohnsonAug 10, 2025
  If your Wabtec Lifting Systems lift is operating abnormally, first check for any obstructions in the lifting frame and remove them, inspecting for damage. Ensure the backup pump manual release valve is turned clockwise until slightly snug. Also, check that the hydraulic fluid level is at the required FULL level while the platform is at ground level, adding Texaco 01554 Aircraft Hydraulic Oil or equivalent U.S. mil spec H5606G fluid if needed. Finally, purge the hydraulic system by operating the lift through its maximum range of travel for at least four complete cycles. If the vehicle doesn't use the full travel of the lift, raise the vehicle on a service hoist or ramp to accomplish the maximum range of travel.
J
Justin SantiagoAug 17, 2025
Why is my Wabtec Lifting Systems lift not working?
- T
  Tracy BurnsAug 18, 2025
  If your Wabtec Lifting Systems lift is not operating, start by resetting the control system circuit breaker. Ensure the backup pump manual release valve is turned clockwise until slightly snug. Check that the hydraulic fluid level is at the required FULL level while the platform is at ground level, adding Texaco 01554 Aircraft Hydraulic Oil or equivalent U.S. mil spec H5606G fluid if needed. Purge the hydraulic system by operating the lift through its maximum range of travel for at least four complete cycles. (For vehicles that do not use full travel of lift, the maximum range of travel is accomplished by raising vehicle on a service hoist or ramp.) For hydraulic hose or fitting leaks, contact an authorized Vapor Ricon dealer for repair.
D
Debra EstesAug 26, 2025
How to fix hydraulic fluid leaks in Wabtec Ricon K1200?
- S
  Stefanie HensleyAug 26, 2025
  If you notice hydraulic fluid leaks in your Wabtec Lifting Systems, first ensure that all hydraulic fittings are properly tightened. If the leak persists, discontinue use of the lift and have repairs made by an authorized Vapor Ricon dealer, as a hydraulic component may be defective.
D
Daniel WhiteSep 2, 2025
What to do if the rollstop doesn't open on my Wabtec Ricon K1200?
- T
  Timothy DickersonSep 2, 2025
  If the rollstop on your Wabtec Lifting Systems does not open, raise the lift and check for any obstruction of the rollstop release latch. Remove any obstruction that you find.