BA 901/1101 en – Edition 2.1 * 91101b510.fm 5-5
Maintenance
5.3 Engine lubrication system
If the engine oil level is too low or if an oil change is overdue, this can cause
Engine damage and loss of output!
☞ Have the oil changed by a Wacker Neuson service center– see
chapter 5.20 Maintenance plan (overview) on page 5-37
Checking the oil level
Check the oil level once a day.
We recommend checking it before starting the engine. After stopping a warm
engine, wait at least 5 minutes before checking.
Checking the oil level
☞ Proceed as follows:
• Park the machine on level ground
• Stop the engine!
• Raise the safety bar
• Let the engine cool down
• Open the engine cover
• Clean the area around the oil dipstick with a lint-free cloth
• Oil dipstick A:
☞ Pull it out
☞ Wipe it with a lint-free cloth
☞ Push it back in as far as possible
☞ Withdraw it and read off the oil level
☞ However if necessary, add oil at the latest when the oil reaches the MIN mark on the oil
dipstick A
Fig. 89: Checking the oil level
To Next Page
