BA 901/1101 en – Edition 2.1 * 91101b330.fm 3-45
Operation
3.22 Maintenance flap
If it is running, the engine stops immediately if the maintenance flap is opened.
The machine can only be started if the maintenance flap is closed.
Closing and opening the maintenance flap –
Injury hazard!
☞ Ensure that neither fingers nor other limbs are squeezed when opening or
closing the maintenance flap.
☞ Do not make any changes or tamper with the maintenance flap switch.
☞ Starting the machine is prohibited.
☞ Put the machine out of operation
– see chapter 3.12 Parking the machine on page 3-32
☞ Remove both screws A and open the maintenance flap.
➥ The maintenance flap cannot be opened completely. A chain prevents any further
opening.
☞ Unlock safety rod B from position C and fasten it on the chassis.
☞ Perform maintenance.
☞ Install both screws A with the corresponding securing elements and tighten them to 110 Nm.
Fig. 90: Maintenance flap
A
To Next Page
Loading...
Need help?
General
