Wacker Neuson 901S User Manual

BA 901/1101 en – Edition 2.1 * 91101b530.fm 5-23
Maintenance
Fitting the wheels
☞ Proceed as follows:
• Place the wheel onto the wheel bolts
• Tighten all wheel nuts part-way
• Raise the machine from the jacks and lower it again on firm and level ground
• Fully tighten the wheel nuts with 175 Nm of torque
Airboss tires (option)
Tire and rim damage does not affect Airboss tires as much as so-called conventional tires.
In case of damage, the separate tire segments A can be replaced quickly and without
removing the entire tire.
An Airboss wheel consists of:
1 steel rim and
20 rubber segments screwed onto the rim.
Removing a tire segment
Proceed as follows:
☞ Remove the four fastening nuts B of a segment.
☞ Remove the segment from the rim.
Installing a tire segment
Proceed as follows:
☞ Fit the new segment onto the rim.
☞ Tighten the four fastening nuts B.
➥ Tightening moment of nuts for tire segments: 13 Nm
Fig. 107: Airboss tires
A
B

Wacker Neuson 901S Specifications

General

Bucket Capacity	0.11 cu yd
Operating Weight (lbs)	2, 976 lbs
Engine Power (hp)	35.7
Tipping Load	2, 976 lbs (1, 350 kg)
Operating Weight (kg)	1, 350 kg
Rated Operating Capacity (kg)	675 kg
Engine Power (kW)	18.5 kW
Width	47.2 in (1, 200 mm)
Travel Speed	6.2 mph (10 km/h)
Bucket Width	47.2 in (1, 200 mm)