EasyManuals Logo

Wacker Neuson BS 60-4 User Manual

Wacker Neuson BS 60-4
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
BS 50-4 Operation
wc_tx000308gb.fm 27
5.7 Proper Operation
See Graphic: wc_gr002612, wc_gr001455
Keep vibratory rammer clean and dry. Avoid no-load strokes. Never
allow the rammer to run full throttle when forcing away material or
when lifting the equipment.
For optimal control, performance, and minimal hand/arm vibration,
grasp handle as shown. Hand/arm vibration (HAV) has been optimized
for this positioning. Reported HAV levels are measured at position A
just in front of the hand position shown in conformance with EN1033
and ISO 5349.
CAUTION: To prevent damage to the rammer, do not allow the
rammer to run on its side.
If the rammer should tip on its side, place the rammer in the position
shown, then shut off the engine by turning engine switch to "OFF".

Other manuals for Wacker Neuson BS 60-4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wacker Neuson BS 60-4 and is the answer not in the manual?

Wacker Neuson BS 60-4 Specifications

General IconGeneral
Engine ManufacturerHonda
Displacement163 cm³
Operating Weight66 kg
Percussion Rate700 blows/min
EngineHonda GX 160
Stroke60 mm
Engine Type4-stroke
Fuel Tank Capacity3.0 liters

Related product manuals