To Next Page
J
Joe NelsonSep 7, 2025
What to do if the air filters are dirty on Wacker Neuson Power Tools?
- JJill WhiteSep 7, 2025
If the air filters on your Wacker Neuson Power Tools are dirty, you should clean or replace them.
What to do if the air filters are dirty on Wacker Neuson Power Tools?
If the air filters on your Wacker Neuson Power Tools are dirty, you should clean or replace them.
What to do if the spark plugs are fouled in Wacker Neuson Power Tools?
If the spark plugs are fouled in your Wacker Neuson Power Tools, you should clean or replace the spark plug and measure the electrode gap.
What to do if there is too much oil in the fuel of Wacker Neuson Power Tools?
If there's too much oil in the fuel of your Wacker Neuson Power Tools, drain the fuel tank and refill it with new mixed fuel.
What to do if the muffler or exhaust port is dirty on Wacker Neuson Power Tools?
If the muffler or exhaust port is dirty on your Wacker Neuson Power Tools, remove and clean the muffler, and clean the exhaust port.
Why is my Wacker Neuson Power Tool engine overheating?
If your Wacker Neuson Power Tool engine is overheating, it could be due to an improper fuel mix, specifically not enough oil. Adjust the fuel mix and add oil to correct this. Another possible reason could be dirty cooling fins and fan blades, so clean them.
General| Impact force/Centrifugal force/Percussion force | 20 kN |
|---|---|
| Base plate/Ramming shoe/Tamping foot width | 280 mm |
| Fuel type | Gasoline |
| Fuel consumption | 0.8 l/h |
| Stroke rate/Impact rate | 700 min-1 |
| Base plate size/Ramming shoe length | 280 mm |
| Fuel tank capacity | 3 l |
