wc_tx003552gb_FM10.fm
38
Rammer
Operation
4.4 Filling the Oil Tank
For rammers with oil injection (BS 50-2i, BS 60-2i, BS 70-2i)
If the rammer has a fuel tank (a) and an oil tank (b), it has oil injection. The oil tank
requires oil.
Requirements
■ Machine shut down
■ Engine cool
■ Machine standing upright on the ramming shoe
■ Wacker Neuson 2-cycle or equivalent oil
Procedure
Perform the procedure below to fill the oil tank.
1. Remove the oil tank cap (c).Fill the oil tank up to the base of the neck (d).
2. Re-install the oil tank cap.
Note: Clean up any spilled oil.
Result
The oil tank has now been filled.
To Next Page
Loading...
Need help?
General
