10 Maintenance
100_0201_mt_0005.fm 27
10.2.1 Clean the machine
1. After cleaning, check cables, lines and unions for loose connections, chafing points and other
damage.
2. Rectify faults found immediately.
10.2.2 Refueling
1. Remove dirt in the area of the fuel cap.
2. Unscrew and remove the fuel cap slowly.
3. Refuel using a clean funnel.
For fuel specification, see section Technical Data.
For fuel mixing table, see section Technical Data.
4. Tighten fuel cap.
10.2.3 Screw joints
All screw joints in vibrating rammers must be checked at regular intervals for firm seating. Loose screw
joints must be retightened to the prescribed or standard torque.
NOTE
Do not use a high pressure cleaner!
Water penetrating can damage the engine, electrical operating elements or components
of the machine.
WARNING
Danger of fire and explosion from fuel and fuel vapors.
Don't smoke.
Do not fill up with fuel in the presence of a naked flame.
Switch off the engine and allow to cool before fueling.
CAUTION
Danger to health from fuel.
Fill up in a well ventilated environment.
Do not inhale fuel vapors.
Avoid skin or eye contact with fuel.
Item Designation
1Fuel cap
NOTE
Screw the fuel cap on slowly so that any excess pressure can discharge slowly.
To Next Page
Loading...
Need help?
General
