BA D18 us* 1.1 * D18w700.fm 7-27
Maintenance 7
Adding engine oil
1. Stop and park the machine. Stop the engine – see “Preparing
lubrication” on page 7-8.
2. Open the maintenance flap on the right.
3. Clean the area around the oil filler cap with a lint-free cloth.
4. Open filler cap C (Tier III) or D (Tier IV).
5. Raise oil dipstick A or B slightly to allow any trapped air to escape.
6. Add engine oil.
7. Wait 5 minutes until all the engine oil has run into the oil sump.
8. Check the oil level.
9. Add oil if necessary and check the oil level again.
10.Close filler cap C or D.
11.Push oil dipstick A or B back in as far as possible.
12.Close and lock the maintenance flap on the right.
To Next Page
Loading...
Need help?
General
