BA EZ17 en* 1.1 * ez17b510.fm 5-23
Operation 5
Hammer operation
Only break in the prescribed work area with shatter protection.
– see chapter “ Shatter protection (option)” on page 4-14
The machine is not certified for demolition work according to EN 474-5.
A front guard cannot be attached.
Danger of piercing/penetration by objects from the front!
Work involving risk of piercing/penetrating by objects from the front can
cause accidents with serious injury or death.
► During operation, all persons must stay clear of the job site of the
machine.
► Observe the mandatory limits of the work area.
► Do not hammer horizontally or upward.
► Only break with the attached shatter protection.
Accident hazard due to tipping over of machine!
A tipping machine can cause serious injury or death.
► During operation, all persons must stay clear of the job site of the
machine.
► The machine can lose its balance and tip over if a hammer or other
heavy attachment is used.
► Never turn, lower or set down the attachment abruptly.
► Do not extend or retract the boom abruptly.
► Do not use the impact force of the attachment to perform demolition
work. Broken or falling pieces can cause serious injury.
► Use a hammer only at machine standstill.
In combination with Powertilt, only use the smallest possible released
hydraulic breaker.
To Next Page
Loading...
Need help?
General
