BA EZ17 en* 1.1 * Safety_01_0.fm 2-21
Safety 2
Working near non-electric supply lines
• Before performing any work, the operator must check whether there
are any non-electric supply lines in the job site.
• If there are non-electric supply lines, the operator must take safety
measures (for example switching off the supply line) in agreement with
the operating company or owner of the supply lines.
• If supply lines are exposed, they must be fastened, supported and
secured accordingly.
Behavior during thunderstorm
• Stop machine operation if a thunderstorm is gathering, stop the
machine, secure and leave it, and avoid being near it.
Noise
• Observe the noise regulations (for example during applications in
enclosed premises).
• Bear in mind external sources of noise (compressed-air hammer,
concrete saw).
• Do not remove the sound baffles of the machine/attachment.
• Have damaged sound baffles immediately replaced (for example an
insulating mat, muffler).
• Before starting work, get informed on the noise level of the machine/
attachment (for example on the adhesive label) – wear ear protectors.
• Do not wear ear protectors during machine travel on public roads/sites.
Clean
• Injury hazard from compressed air and high-pressure cleaners.
- Wear appropriate protective clothes.
• Do not use any dangerous and aggressive detergents.
- Wear appropriate protective clothes.
• Operate the machine only in a clean condition.
- Remove all dirt, snow and ice from climbing aids (for example
handholds, footholds, handrails).
- Keep the cabin glazing and visual aids clean.
- Keep the light system and reflectors clean.
- Keep the control elements and indicators clean.
- Keep the safety, warning and information labels clean, and replace
damaged and missing labels by new ones.
• Perform cleaning work only if the engine is stopped and cooled down.
• Bear in mind sensitive components and protect them accordingly (for
example electronic control units, relays).
To Next Page
Loading...
Need help?
General
