4-40 BA E16 en* 1.0 * E16_10_400.fm
4 Putting into operation
Possible damage if the engine is started again immediately after stopping
it.
► Wait at least two minutes before starting the engine again.
Damage to preheater if the preheating system is operated too long.
► Never preheat the engine more than five seconds.
1. Insert the starting key.
2. Turn the starting key to position 1.
3. All control lamps light up for a few seconds.
➥ If an indicator light does not function, contact an authorized service
center.
4. Turn and hold the starting key in position 2 until the indicator light for
preheating (E) goes out.
➥ The telltale lights engine oil pressure (F) and alternator charging (C)
are illuminated.
5. Turn the starting key to position 3 until the engine runs.
➥ All indicator lights go out.
➥ If the engine does not start after 10 seconds:
6. Interrupt the start procedure and repeat it after two minutes.
➥ If the engine still does not start after a few tries, contact an
authorized service center and have the error rectified.
7. Release the starting key as soon as the engine runs.
The engine will not start unless the left-hand control lever base is raised.
Fig. 115 Telltale lights tier III
F
E
C
Fig. 116 Telltale lights tier IV
A B C D
E F C
To Next Page
Loading...
Need help?
General
