OM ET18/20/24 us 1.3 * et18_20_24t900.fm 9-45
9
ET18
Standard /
telescopic travel
gear
Telescopic travel
gear +
VDS
A Height 2290 mm (7'-6'') 2390 mm (7'-10'')
B1 Upper carriage width 990 mm (39 in)
B2 Width with retracted travel gear 990 mm (39 in)
B2 Width with extended travel gear (telescopic travel gear only) 1300 mm (51 in)
C Transport length 3855 mm (12'-8'') 3800 mm (12'-6'')
D1 Max. digging depth (short stick) 2200 mm (86 in) 2100 mm (83 in)
D2 Max. digging depth (long stick) 2400 mm (94 in) 2300 mm (91 in)
E1 Max. vertical digging depth (short stick) 1420 mm (56 in) 1320 mm (52 in)
E2 Max. vertical digging depth (long stick) 1610 mm (63 in) 1500 mm (59 in)
F1 Max. digging height (short stick) 3450 mm (11'-4'') 3550 mm (11'-8'')
F2 Max. digging height (long stick) 3560 mm (11'-8'') 3660 mm (12'-0'')
G1 Max. dump height (short stick) 2500 mm (98 in) 2610 mm (8'-7'')
G2 Max. dump height (long stick) 2620 mm (8'-7'') 2720 mm (8'-11'')
H1 Max. reach at ground level (short stick) 3700 mm (12'-2'') 3670 mm (12'-0'')
H2 Max. reach at ground level (long stick) 3900 mm (12'-10'') 3870 mm (12'-8'')
K1 Max. digging radius (short stick) 3800 mm (12'-6'')
K2 Max. digging radius (long stick) 4000 mm (13'-1'')
M Max. boom displacement to bucket center (right-hand side) 520 mm (20 in)
N Max. boom displacement to bucket center (left-hand side) 360 mm (14 in)
O Max. lift height of stabilizer blade over ground (short) 200 mm (8 in) 270 mm (11 in)
O Max. lift height of stabilizer blade over ground (long) 300 mm (12 in) 360 mm (14 in)
P Max. scraping depth of stabilizer blade below ground surface (short) 320 mm (13 in) 260 mm (10 in)
P Max. scraping depth of stabilizer blade below ground surface (long) 380 mm (15 in) 310 mm (12 in)
R1 Min. tail end slewing radius 1160 mm (46 in)
R2 Boom swivel radius (center) 1580 mm (62 in)
R3 Boom swivel radius (right) 1500 mm (59 in)
R4 Boom swivel radius (left) limit 1380 mm (54 in)
R5 Max. boom swivel radius (left) 1280 mm (50 in)
S Total running gear length (standard travel gear) 1460 mm (57 in) -
S Total running gear length (telescopic travel gear) 1605 mm (63 in)
T Running gear length (Turas front idler) (standard travel gear) 1080 mm (42 in) -
T Running gear length (Turas front idler) (telescopic travel gear) 1225 mm (48 in)
V VDS tilt angle - 0 – 15°
W1 Max. tilting angle of boom to the right 48°
W2 Max. tilting angle of boom to the left-hand limit 64°
W3 Max. tilting angle of boom to the left 77°
X Track width 230 mm (9 in)
Y1 Stabilizer blade width 990 mm (39 in)
Y2 Stabilizer blade width with extension (only telescopic travel gear) 1300 mm (51 in)
Z Stabilizer blade height 230 mm (9 in)
To Next Page
Loading...
Need help?
General
