G 3.7A;G/GS 5.6A;GS 8.5V;GS 9.7V Portable Generator Repair
wc_tx000208gb.fm 60
Running Generator
Follow instructions below and read starting and stopping instructions
found in Engine Owner’s Manual.
6.16.1 Disconnect all loads from the generator and place the main circuit
breaker in the open position. Place auto-idle switch to OFF position
(G 3.7A, G 5.6A, GS 5.6A, GS 8.5V, and GS 9.7V models).
6.16.2 Open fuel valve.
6.16.3 If engine is cold, pull choke control out. If engine is hot, push choke
control in.
6.16.4 For electric start models, turn “Key Switch” to start position, and hold
until engine starts.
CAUTION: Do not crank engine longer than 15 seconds at a time.
Extended cranking can damage starter motor.
To start engine using manual start, turn key switch to the run position.
Pull starter rope rapidly to start engine.
Leave key in run position while engine is running.
Note:
The engine is equipped with a low oil protection system. If the oil
level is low, the engine will not start. Check engine oil level if engine
does not start.
6.16.5 Push choke in as engine warms.
6.16.6 Place main circuit breaker in closed position and place auto idle switch
in ON position. Allow engine to warm up and check function of GFI
circuit breakers before attaching loads to generator.
To Next Page
Loading...
Need help?
General
