Maintenance PT 2/3 /...
wc_tx000013gb.fm 19
4.2.9 Release filter screw (d) by hand and pull the oil filter out of its housing.
4.2.10 Use an air line to blow out oil filter dirt from the inside outwards.
4.2.11 Lightly oil the gaskets (c).
4.2.12 Refit the oil filter. Apply slight pressure towards the engine block and
tighten by hand.
4.2.13 Add engine oil.
4.2.14 Run for a short interval, then check at drain plug (b) for any leaks.
Tighten if necessary.
wc_gr002682
c
b
e
d
To Next Page
