Maintenance WM 130/170/270
wc_tx000242gb.fm 26
6.3 Engine Oil
See Graphic: wc_gr000087
6.3.1 Drain oil while engine is still warm.
Note: In the interests of environmental protection, place a plastic sheet
and a container under the machine to collect any liquid which drains
off. Dispose of this liquid in accordance with environmental protection
legislation.
6.3.2 Remove the oil drain plug (a).
6.3.3 Allow the oil to drain.
6.3.4 Install the drain plug.
6.3.5 Fill the engine crankcase through the oil filler opening (b), to the upper
mark on the dipstick (c). Do not thread in the dipstick to check the level.
See Technical Data for oil quantity and type.
6.3.6 When the crankcase is full, reinstall the dipstick.
6.4 Cleaning Fuel Strainer
See Graphic: wc_gr001093
6.4.1 To remove water and dirt, close the fuel lever and remove the fuel
strainer.
6.4.2 Inspect fuel strainer (a) for water and dirt.
6.4.3 After removing dirt and water, wash the fuel cup with kerosene or
gasoline.
6.4.4 Reinstall securely to prevent leakage.
w c _ g r 0 0 0 0 8 7
=
>
?
wc_gr001093
a
To Next Page
Loading...
Need help?
General
