HAVING TROUBLE?
Page 124
Contents
Index
Changing the function settings
for the Intuos2 tools has no
effect.
Make sure that you change the settings for the tool and the application
that you are using. See W
orking with Multiple Tools and Working with
Application-Specific Settings.
The screen cursor jumps back. When your Intuos2 tool is not in use, place it in the pen stand or some
location near the tablet, but not on the tablet. Leaving your tool on the
tablet may interfere with screen cursor positioning when using other
input devices.
When using the tablet the
screen cursor is very erratic or
jumps around.
On rare occasions the tablet may receive interfering radio frequencies
from a computer monitor or nearby AM radio station. If you notice
interference, try the following:
• Set the tablet to S
INGLE MODE. For USB tablets this option is
located on the T
ABLET MODE tab.
• Move the tablet at least 6 inches away from the monitor, or change
the refresh rate or monitor resolution.
To Next Page
Loading...
Need help?
General
