To Next PageTo Next PageWhat to do if Waeco ASC3000G Air Conditioner displays “Warning! Internal vessel over- pressure!”?
This message appears during the recycling process. To continue, press ENTER for three seconds. If the message appears repeatedly, contact customer services.
Why does my Waeco ASC3000G display “Warning! Not enough vacuum for injection!”?
This message appears during the filling phase if the vacuum in the air conditioning system is insufficient to end the process. Check the air conditioning system or the connections between it and the AirConServiceCenter for leaks.
What does “Drained oil glass emptying!” mean on my Waeco ASC3000G Air Conditioner display?
This message appears during the extraction or recycling process if there is more than 150 ml of used oil in the container. Dispose of the content of the used oil container in an environmentally responsible manner.
What to do if Waeco ASC3000G Air Conditioner displays “Quantity too large. Fill internal vessel!” message?
This message appears during the process input if there is not enough refrigerant in the internal container to complete the process. Fill the refrigerant container.
What should I do if my Waeco Air Conditioner displays “Not enough UV. Add!”?
This message appears during the filling process if there is not enough UV additive in the container to finish the process. Fill the UV additive container.
Why does Waeco ASC3000G display “Warning! Internal vessel full!”?
The message indicates that the internal refrigerant container is too full to hold the quantity to be extracted. Drain the internal refrigerant container in the proper manner.
What to do if Waeco ASC3000G displays “Not enough oil. Add!”?
This message appears during the filling process if there is not enough fresh oil in the container to finish the process. Top up the fresh oil container with a suitable oil type.
What does it mean when my Waeco ASC3000G Air Conditioner displays “Warning! Pressure inside the A/C system!”?
This message appears during the vacuum process, indicating pressure in the air conditioning system. No action is needed; the process continues automatically.
Why does my Waeco ASC3000G display “Warning! Pressure inside the A/C system. Recovery start!”?
This message appears at the start of the vacuum process because there is still pressure present in the air conditioning system. No action is required as the process will continue automatically.
How to fix Waeco ASC3000G when display shows “Printer not in line! Carry on?”?
The message indicates that the printer has a fault. Check if there is paper in the printer, ensure the printer is switched on (the yellow LED must be constantly lit), and verify that the cover is properly closed.
General| Brand | Waeco |
|---|---|
| Model | ASC3000G |
| Category | Air Conditioner |
| Language | English |
Essential precautions for safe operation, maintenance, and user protection.
Identifies visual warnings and safety symbols displayed on the AirCon Service Center unit.
Describes the built-in safety mechanisms such as pressure monitors and relief valves.
Step-by-step guide for physical installation and initial device activation.
Procedure for charging the internal refrigerant container for the first time.
Initiates a fully automated air conditioning service with minimal user input.
Covers creating, entering, and managing personal user codes for system access.
Procedure for checking and resetting the zero point of the scales for oil and UV additive.
Step-by-step guide for replacing the internal dryer filter of the unit.
Instructions to calibrate the pressure sensor for accurate measurements.
Detailed process for draining and refilling the vacuum pump with new oil.
A guide to diagnosing and resolving common error messages and issues.
