What does “Error 60” mean on my Waeco ASC3000G?
During the hybrid service (flushing the service hoses with hybrid oil), a vacuum could not be achieved. Check if the service hoses are connected to the hybrid flush container, if the hybrid flush container is fitted the right way round, and the connections for leaks.
How to fix Waeco ASC3000G when display shows “Printer not in line! Carry on?”?
The message indicates that the printer has a fault. Check if there is paper in the printer, ensure the printer is switched on (the yellow LED must be constantly lit), and verify that the cover is properly closed.
Why does my Waeco ASC3000G display “Warning! Pressure inside the A/C system. Recovery start!”?
This message appears at the start of the vacuum process because there is still pressure present in the air conditioning system. No action is required as the process will continue automatically.
What does it mean when my Waeco ASC3000G Air Conditioner displays “Warning! Pressure inside the A/C system!”?
This message appears during the vacuum process, indicating pressure in the air conditioning system. No action is needed; the process continues automatically.
What to do if Waeco ASC3000G displays “Error 61”?
Pressure increased during the hybrid service. Check if the service hoses are connected to the hybrid flush container, if the hybrid flush container is fitted the right way round, and if the service couplings are open.
What to do if Waeco ASC3000G displays “Error 04”?
This message indicates that it is not possible to lower the pressure when flushing takes place. Check the air conditioner and connections for leaks, constrictions, and ice build-up. Check the pressure transducer calibration.
What does it mean if my Waeco ASC3000G displays “Error 02”?
This message means the pressure increased again with the pressure increase test, and it is not possible to reduce pressure sufficiently. Check the air conditioner and connections for leaks, constrictions, and ice build-up. Check the pressure transducer calibration.
What to do if Waeco ASC3000G Air Conditioner displays “Error 03”?
This message indicates that no data is coming from the refrigerant scale. Check the scale.
What does it mean when my Waeco ASC3000G Air Conditioner displays “A/C system leakage! Carry on?”?
This message appears at the end of the vacuum process. The air conditioning system shows a vacuum loss of more than 120 mbar during the checking time. Check the air conditioning system or the connections between it and the AirConServiceCenter for leaks.
Why does my Waeco ASC3000G display “Warning! Not enough vacuum for injection!”?
This message appears during the filling phase if the vacuum in the air conditioning system is insufficient to end the process. Check the air conditioning system or the connections between it and the AirConServiceCenter for leaks.
Essential precautions for safe operation, maintenance, and user protection.
Identifies visual warnings and safety symbols displayed on the AirCon Service Center unit.
Describes the built-in safety mechanisms such as pressure monitors and relief valves.
Step-by-step guide for physical installation and initial device activation.
Procedure for charging the internal refrigerant container for the first time.
Initiates a fully automated air conditioning service with minimal user input.
Covers creating, entering, and managing personal user codes for system access.
Procedure for checking and resetting the zero point of the scales for oil and UV additive.
Step-by-step guide for replacing the internal dryer filter of the unit.
Instructions to calibrate the pressure sensor for accurate measurements.
Detailed process for draining and refilling the vacuum pump with new oil.
A guide to diagnosing and resolving common error messages and issues.
General| Brand | Waeco |
|---|---|
| Model | ASC3000G |
| Category | Air Conditioner |
| Language | English |
To Next Page