What to do if the electric circuit between the pins in the compressor of my Waeco CoolMatic CRX50 Refrigerator is interrupted?
If the electric circuit between the pins in the compressor of your Waeco Refrigerator is interrupted, it is due to a defective compressor. The solution is to replace the compressor.
Why is my Waeco CoolMatic CRX50 Refrigerator making unusual noises?
If your Waeco Refrigerator is making unusual noises, it could be because a component of the refrigerant circuit cannot move freely (touching the wall) or there is a foreign object stuck between the cooling unit and the wall. To fix this, bend the component carefully away from the obstruction or remove the foreign object.
Why the compressor of my Waeco Refrigerator doesn't run when voltage is present?
If voltage is present, but the compressor of your Waeco Refrigerator doesn't run, it is because the ambient temperature is too high.
Why is the electronics unit of my Waeco Refrigerator overheating?
If the electronics unit of your Waeco Refrigerator is overheating, it may be because the cooling system is loaded too heavily or the temperature is set too high.
Why is the speed of my Waeco CoolMatic CRX50 Refrigerator too low?
If the speed of your Waeco Refrigerator is too low, it indicates that the cooling system is overloaded, preventing the motor from maintaining its minimum speed of 1,850 rpm.
What causes the motor of my Waeco CoolMatic CRX50 Refrigerator not to start?
If the motor of your Waeco Refrigerator doesn't start, it could be due to the rotor being jammed or the pressure difference in the cooling system being too high (greater than 5 bar).
General| Freezer Volume | 4.4 L |
|---|---|
| Power Consumption | 40 W |
| Voltage | 12/24 V DC |
| Temperature Range | +10 °C to -18 °C |
| System | Compressor |
| Colour | Silver |
| Refrigerant | R134a |
| Insulation | Polyurethane foam |
To Next Page
