©2016 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User’s Manual—Read before using this equipment
www.wagan.com
11
USB POWER PORT
1. Connect a user-supplied USB cable to the USB power port on the Battery Jumper.
2. Press the USB/Battery Status button to activate the USB port.
3. When charge is complete, disconnect the USB cable from the Battery Jumper and press the
USB/Battery Status Button to turn it off..
WORKLIGHT
The worklight has 2 settings.
1. Press the power button (located under the Battery Jumper handle) once for a
white worklight.
2. Press again for a red beacon.
3. Press a third time to turn it off.
4. Turn the light off when it is not in use.
To Next Page
Loading...
