ENGLISH
11
User’s Manual—Read before using this equipment
DC POWER PORT
For proper and safe operation of the DC power accessory outlet, do not place anything into it
except the plug of the accessory to be used.
Overloading the port may result in “tripping” a self-resetting circuit breaker. Removing the overload
automatically restores power to the DC Power Port.
1. Insert the DC connection cable into the DC output port.
2. Select the appropriate connection head and attach to the other end of the cable.
3. Set master switch to the “I” position.
4. Using the MODE button, press (not hold) to select the voltage your device requires. Do not
connect to device until proper output voltage is set.
5. Connect DC cable to the device you wish to charge.
6. After use, turn off the master switch (“O” position).
7. Recharge the iOnBoost as soon as convenient.
USING THE USB SOCKET
If the charge in the iOnBoost is low, the USB port will shut off to prevent damage to the iOnBoost.
Recharge the iOnBoost as soon as convenient.
1.
C
onnect the USB device to the iOnBoost with either a user-supplied cable or the included 4-in-
1 USB adapter.
2.
S
lide the master switch to the “I” position.
3.
W
hen your mobile device is fully charged, disconnect your device from the iOnBoost and slide
the master switch back to “O”.
LED FLASHLIGHT
The light will automatically shut off before the iOnBoost runs out of power.
1.
S
et master switch to the “I” position.
2.
H
old down the “MODE” button until the indicator lights turn on (~3 seconds).
3.
P
ress once to switch lighting modes: steady – SOS – flashing – off.
4.
A
fter use, turn off the master switch (“O” position). Recharge battery as soon as convenient.
PROPER DISPOSAL
• This product has no consumer serviceable parts.
• Do not attempt to remove or replace the battery used in this device. When
the battery has reached the end of its lifetime, please take the entire unit to a battery recycling
facility.
To Next Page
Loading...
Need help?
General
