EasyManuals Logo

Wagan JumpBoost V10 Air User Manual

Wagan JumpBoost V10 Air
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
©2017 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User’s Manual—Read before using this equipment
www.wagan.com
13
5. Determine if you will need an air hose adapter for your object.
To inflate a vehicle tire:
a. Remove the valve cap from the valve stem of the tire.
b. Attach the chuck of the air hose to the tire’s valve stem.
c. Push the chuck lever down to secure the chuck to the valve stem.
To inflate a sports equipment, air mattress, rafts, or other plastic inflatables:
a. Insert the proper valve stem adapter into stem connector as far as possible.
b. Push the chuck lever down to secure the adapter.
c. Remove the valve cap from your inflatable object if there is one.
d. Insert the other end of the valve stem adapter into inflatable’s air valve opening
as far as possible.
6. Set the Air Compressor Switch on to the “I” position to start inflation.
7. Monitor the pressure gauge while inflating the tire.
8. When recommended tire pressure has been reached, turn off the air compressor.
9. Disconnect the hose and replace valve cap.
10. Return the hose back to its compartment for storage.
11. Recharge the JumpBoost as soon as it is convenient.
DC OUTPUT SOCKET
The DC accessory socket can power a DC load up to 11 Amps. Overloading the socket will result
in tripping a self-resetting circuit breaker. Removing the overload automatically restores power to
the DC socket. For proper and safe operation of the 12 Volt DC power accessory outlet, do not
place anything into it except the 12V DC plug of the accessory to be used.
1. Check the required current draw of the appliance/device to be powered and make sure it
does not exceed the JumpBoosts maximum wattage.
2. Open the dust cover from the DC socket.
3. Insert the 12V DC accessory plug into the socket.
4. Operate the appliance as usual.
5. After use, disconnect the accessory plug from the DC socket.
6. Replace the dust cover.
7. Recharge the JumpBoost as soon as convenient.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wagan JumpBoost V10 Air and is the answer not in the manual?

Wagan JumpBoost V10 Air Specifications

General IconGeneral
BrandWagan
ModelJumpBoost V10 Air
CategoryRemote Starter
LanguageEnglish

Related product manuals