Seite:14
Specific noise values
The according to the EN 23746 for the sound pressure level resp. EN 31202 (correction factor k3 after supplement A.2
from EN 31204 calculated) for the sound pressure level on the working site ascertained noise emission value amounts
under the foundations of ISO 7904 supplement A performed working conditions to:
Sound pressure level in dB
Idle LWA / Processing LWA
dB(A) 105 / 107 105 / 107 105 / 107
Sound pressure level on working site in dB
Idle LpAeq / Processing LpAeq
dB(A) 85 / 92 95 / 97 95 / 97 95 / 97
The specified values are emission values and therefore should not at the same time be reliable working site values. Although
there is a correlation between emission and immision levels, it cannot unfailingly be derived if extra precautions need to be
taken or not. Factors, which influence the actual availabe immusion value on working site, include the peculiarities of wor-
king area, other sources of noise, e.g. the number of machines and other adjoining processes. The allowed working values
could vary from country to country. However, the information should qualify the user, to be able to make an estimation of the
dangers and risks.
Assembly
The machine is delivered, except for the handle bar, completely assembled and is therefore immediately ready to operate.
Demount the handle bar from the rocker joint and insert it into the left frame side wall.
Setting-up and adjustment
Please pay attention that your rocker circular saw is set up stable and on a leveled floor.
Technical information
Wagner 700 Wagner 700s Wagner z700
Construction measurements:
Total length mm 1270 1270
Total width mm 730 730 1070
Total height mm 1130 1130 1130
Rocker support mm 655 655 655
Saw blade Ø max. mm 700 700 700
Idle - Motor 1/min. 1400 1400 max. 540
Cutting speed- Saw blade m/sec. 51 51 51
Weight kg 107,5 112 115
Power unit: 1530 0901 10DE 1530 0914 10DE
Motor V 380-420 / 50Hz 380-420 / 50Hz
Input power P1 KW 5,2 7,5
Output power P2 KW 4,0 6,0
Motor speed 1/min. 1400 1400
Operating mode S6/40% S6/40%
Rated current A 9,3 12,5
Power unit: 1530 0915 10DE
Gelenkwellendrehzahl
1/min.. max. 540
Work information
Cutting height
Spar max. mm 240 240 240
Turning cut max. mm 250 380 380
Piece of wood max. mm 380x240 420x240 420x240
Technical subject to alterations!
To Next Page
Loading...