21
Control Pro 350 Extra Cart
GB
minutes. Eliminate the cause of heating, e.g. slots for air intake covered.
Description (Fig. 1)
1 Hose holder 2 Inlet valve pusher
3 Telescopic handle 4 Integrated toolbox for nozzles and small parts
5 Pressure regulator with integrated ON/OFF switch 6 Hose connection
7 Selector switch 8 Holder for paint container
9 Pressure gauge 10 Suction hose
11 Return hose 12 Inlet lter
13 Operating instructions 14 High-pressure hose
15 Gun extension (30 cm) 16 Spray Gun
17 Nozzle 515 (for thick materials, e.g. interior wall paints) 18 Nozzle holder
19 HEA Filter Set 20 Gun lter: red (1 pc.), white (1 pc.*)
21 Nozzle 311 (for thin materials, e.g.
lacquers) 22 Nozzle 619 (for thick materials, e.g. interior wall paints. For
coating larger surfaces)
* pre-installed in the lter housing
Coating Materials Suitable for Use
Dispersion and latex paints for interior use.
Water-based and solvent-containing lacquers and glazes. Paints, oils, release agents, synthetic enamels, PVC lacquers, undercoats,
base coats, llers and anti-rust paints.
i
Another nozzle size and gun lter must be used, depending on the material to be processed.
Thin materials: Nozzle 311
Filter red
Thick materials: Nozzle 515/619
Filter white
Coating Materials Not Suitable for Use
Materials that contain highly abrasive components, facade paint, caustic solutions and acidic coating substances.
Flammable materials, materials containing acetone or cellulose thinner
i
In order to ensure compatibility of the coating substance with the materials used to manufacture the device, please
contact Wagner Service in cases of doubt.
Field of application
Coating interior walls and outside objects (e.g. garden fences, garage doors, etc.).
Required tools and auxiliary material
•
Wrench (13, 16, 17, 20) and/or adjustable wrench (2 pcs.) and hex key (10 mm)
•
Hex key (2.5 mm)
•
Empty container
•
A large piece of cardboard
•
Covering material
Preparation of the workplace
Sockets and plugs must be masked. Risk of an electric shock as a consequence of sprayed material entering the
socket!
Mask all the areas and objects that are not to be spray painted, or remove them from the work area.
No liability is assumed for damage due to overspray.
Silicate paint corrodes glass and ceramic surfaces upon contact! All such surfaces must therefore be completely
covered.
To Next Page
Loading...
