25
Control Pro 350 Extra Cart
GB
i
Under pressure, the nozzle may be very dicult to turn. Turn the switch to the PRIME position (vertical) and pull the
trigger. This will relieve pressure and the tip will turn more easily.
2. Turn the switch to the SPRAY position (horizontal).
3.
Unlock the gun and squeeze the trigger, pointing the gun at a scrap piece of
wood or cardboard. This allows pressure in the spray hose to blow out the
obstruction. When the nozzle is clean, material will come out in a straight, high
pressure stream.
4. Release the trigger and secure the gun. Reverse the nozzle so the arrow
points forward again. Unlock the gun and resume spraying.
i
The HEA Filter Set keeps nozzle blockages to a minimum (see “HEA Filter Set”).
HEA Filter Set
Assembly
Danger
The gun and high-pressure hose must be de-pressurised before
the lter set is installed / removed.
1. Disconnect the high-pressure hose from the gun (1).
2. If necessary, screw on the lter housing (2) and insert a lter (3) appropriate
to the nozzle (the conical side (A) must point upwards).
Nozzle 311
Filter red
Nozzle 517 / 619
Filter white (pre-installed in the lter housing)
3. Screw the lter housing (2) to the gun (1).
4. Screw the high-pressure hose (4) rmly to the lter housing (2).
Cleaning
Danger
The gun and high-pressure hose must be de-pressurised before
the lter set is installed / removed.
1. Remove the lter housing (2) from the hose (4) and the gun (1).
2. Screw on the lter housing (2) and remove the lter (3).
3. Thoroughly clean the lter (3) and lter housing (2) (if worn, replace the lter).
4. During reassembly, take care not to lose the seal and spring.
Interruption of Work
Danger
Be sure to follow the Pressure Relief Procedure when shutting the unit o for any purpose.
This procedure relieves the pressure from the spray hose and the gun.
Watch the pressure gauge ––> 0 bar
•
Switch the device o (pressure regulator in position 0) and remove the power plug.
•
Put the spray gun in a plastic bag and seal so that it is air-tight.
•
Wet paint surface in paint container with a little water to prevent a skin from forming.
Taking Out of Operation and Cleaning
Proper cleaning is the prerequisite for problem-free operation of the paint application device. No warranty claims are accepted
in case of improper or no cleaning.
Danger
Do not use ammable materials / cellulose thinner for cleaning purposes.
i
Always clean the device as soon as you have nished operation.
Dried-on coating substance makes cleaning more dicult.
3
1
2
4
A
To Next Page
Loading...
