9
English
Troubleshooting (continued)
Problem C: Atomization is too coarse
Cause Solution
1. Viscosity of material too high. Thin.
2. Material volume too large. Decrease volume setting (-).
3. Material volume setting too high (+). Decrease volume setting (-).
4. Pressure setting too low. Increase pressure setting (+).
5. Nozzle clogged. Clean.
6. Air lter clogged. Change.
7. Too little pressure build-up in container. Tighten container.
Problem D: Spray jet pulsates
Cause Solution
1. Material in container running out. Rell.
2. Air lter clogged. Change.
Problem E: Pattern runs or sags
Cause Solution
1. Applying too much material. Adjust material ow or increase movement of spray gun.
Problem F: Too much overspray
Cause Solution
1. Gun too far from spray object. Reduce distance.
2. Too much material applied. Decrease volume setting (-).
3. Pressure setting too high. Decrease pressure setting.
Problem G: Pattern is very light and splotchy
Cause Solution
1. Moving the spray gun too fast. Adjust material ow or decrease movement of spray gun.
Have you tried the recommendations above and
are still having problems? In the United States, to
speak to a customer service representative, call
our Technical Service at 1-800-328-8251 Monday
through Friday between 8:00 AM and 4:30 PM
Central time.
Product Registration
Register your product online at www.wagnerspraytech.com.
Proper registration will serve as proof of purchase in the
event your original receipt becomes misplaced or lost.
To Next Page
Loading...
