Important notes on product liability
As a result of an EC regulation being effective as from
January 1, 1990, the manufacturer shall only be liable
for his product if all parts come from him or are
released by him, and if the devices are properly
mounted and operated.
If the user applies outside accessories and spare
parts, the manufacturer´s liability can fully or partially
be inapplicable; in extreme cases usage of the entire
device can be prohibited by the competent authorities
(employer´s liability insurance association and factory
inspectorate division).
Only the usage of original WAGNER accessories and
spare parts guarantees that all safety regulations are
observed.
Technical data Plast Coat 15
Voltage: 230 V ~, 50 Hz
Fuse protection: 16 A slow-blow
Device mains cable: 6 m long, 3 x 1.5 mm
2
Socket on the control unit
max. load: 450 watts
Motor output P
1
:1.5 kW
Max. feed rate (water): 11 l / min
Max. operating pressure: 40 bar
Max. grain size: K 4 mm
Measurements L x W x H: 1180 x 530 x 660 mm
Receptacle capacity: 60 l
Weight: 70 kg
Tire pressure, max.: 2.5 bar
Protective system: IP 54
Max. sound pressure level: 70 dB (A)*
Atomization air connection: Rapid action coupling
DN 7 mm
Max. atomization air pressure: 10 bar
Required volume of
compressed air, min: 220 l/min
Texture nozzle: 8 mm (standard)
Mortar hose: DN 27 mm,
10 m (standard)
* Measured at a distance of 1 m to the side and at a
height of 1.6 m over the device, reverberant floor.
Tool specification
Part No.
Carrier sleeve take-off device 0348 950
3
To Next Page
Loading...
