Need help?Do you have a question about the WAGNER TITANIUS TOP-SENS and is the answer not in the manual?
General| Brand | WAGNER |
|---|---|
| Model | TITANIUS TOP-SENS |
| Category | Smoke Alarm |
| Language | English |
Manual for installers, engineers, and technicians.
Explains safety symbols like WARNING, NOTICE, and TIP.
Details sensitivity, alarm levels, LOGIC·SENS, air flow monitoring, networkability.
Suitable for early and very early smoke detection in various environments.
Overview of the basic device and pipe system components.
Describes detector module, alternative sensitivity, and LOGIC·SENS.
Overview of optional components like network modules and displays.
Using diagnostic software to read device status and faults.
Overview of available pipe components like filters, traps, and elbows.
Describes project planning according to EN 54-20 or ISO 7240-20.
Rules for ensuring equal air intake and design limits.
Requirements for recognizing air flow changes and adjustment levels.
Divides sensitivity into fire classes (A, B, C) and selectable levels.
Defines limit values for pipe length and apertures.
Regulations, guidelines, and instructions for installation.
Configuration of detector module, alarm, and air flow settings.
Sets sensitivity via switch S1 (1, 2) on the detector module.
Choosing the mounting location for clear display visibility.
Preparing and feeding cables through entries.
Step-by-step guide for replacing a detector module.
Pipes, hoses, and fittings must meet Class 1131 requirements.
Cutting pipes, cleaning joints, and ensuring airtight connections.
Calculation of length changes due to temperature variations.
Designing and positioning apertures with aspiration-reducing film sheets.
Installing ceiling feed-through in false ceilings.
Assembling capillary hose and upstream blind.
Checking settings before connecting to power supply.
Adjusting the air flow sensor for the connected pipe system.
Adjusting sensor without considering air pressure.
Adjusting sensor based on current air pressure.
Checking detector module and transmission to FAS.
Verifying detection of pipe fracture or blockage.
Performing the operational check with or without a manometer.
Checks for accessibility, blockages, tightness, and damage.
LED indications for different faults and device conditions.
Step-by-step guide for replacing a detector module.
Cleaning or changing filter inserts.
Checking air flow adjustment using diagnostic software.
To Next Page
