4. Description/ Scope of delivery
Description/ Scope of delivery (Fig. 1)
1 Air cup 11 Air lter
2 Nozzle 12 Air screen
3 Union nut 13 Mains lead
4 Standard spray attachment 14 Spray gun holder
5 Trigger guard 15 Container
6 Material volume regulation 16 Ventilating hose
7 Handle 17 Valve
8 Combined ON/OFF and speed switch 18 Stirring rod
9 Air hose 19 Replacement nozzle seal*
10 Carrying belt 20 Lubricating grease (without illustration)*
* This is inside the container: remove it before starting operations!
5. Coating Materials Suitable for Use
Water- and solvent-based paints, nishes, primers, 2-component paints, clear nishes,
automotive nishes, staining sealers and wood sealer-preservatives.
6. Coating Materials Not Suitable for Use
Materials that contain highly abrasive components, facade paint, caustic solutions and
acidic coating substances. Flammable materials.
7. The following materials can only be processed with
optional accessories:
Interior wall paint (dispersions and latex paint)
8. Preparation of the Coating Material
The enclosed spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted. Detailed information is available in the technical data sheet
of the manufacturer ( Internet Download).
1. Stir the material up and put the required amount into the paint container.
Thinning recommendation
Sprayed material
Glazes undiluted
Wood preservatives, mordants, oils, disinfection agents,
plant protective agents undiluted
Paints containing solvents and water-soluble paints,
primers, vehicle coating paints, thick-lm glazes dilute by 5 - 10 %
2. If the convey capacity is too low, add 5 - 10 % dilution step-by-step until the convey
To Next Page
Loading...
