WAGNER W 300 - Technical Specifications

28
W 300
GB
Problem Cause Remedy
Device does not
function
•
Device overheated ➞ Unplug the power plug,
let the device cool down
approx. 30 minutes, do not
bend the hose, check the
air lter, do not cover the
intake slots
Paint in the
ventilating hose
•
Diaphragm soiled
•
Diaphragm defective
➞ Clean the diaphragm
➞ Replace the diaphragm
23. Technical Data
Technical Data
Max. viscosity: 130 DIN-s
Power source: 230 V
~
, 50 Hz
Power consumption: 350 W
Atomizing output: 105 W
Max. ow rate: 125 ml/min
Double insulation:
Sound pressure level*: 80 dB (A); Uncertainty K = 4 dB
Sound pressure output*: 93 dB (A); Uncertainty K =4 dB
Oscillation level*: < 2.5 m/s²; Uncertainty K = 1.5 m/s²
Air hose length: 1,8 m
Weight: approx. 2.8 kg
* Measured in accordance with EN 60745-1
Information about the oscillation level
The specied oscillation level has been measured according to a standard test
procedure and can be used to compare against electric tools.
The oscillation level is also for determining an initial assessment of the vibrational strain.
Attention! The vibration emission value can dier from the specied value when the
electric tool is actually in use, depending on how the electric tool is being used. It is
necessary to specify safety measures to protect the operating personnel. These measures
are based on an estimated shutdown during the actual conditions of use (all parts of the
operating cycle are taken into consideration here, for example periods when the electric
tool is switched o, and, when it is switched on but running without any load).