3)
Place the ventilating hose (Fig. 10, 14) on the valve cover and on the nipple at the
gun body.
4)
Push the nozzle seal (g. 12, 4) over the needle (20); the groove (slot) should point
towards you.
5) Put the nozzle onto the gun body and nd the correct position by turning it.
6) Put the air cap onto the nozzle and tighten it using the union nut.
7) Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
8) Insert the suction tube with container seal in the gun body.
16. Maintenance
WARNING! Never operate the machine without the air lter; dirt could be sucked in
and interfere with the function of the machine. Disconnect plug before
changing parts.
Change the air lter if it is soiled. Remove air lter cover. (Fig. 13, a) Replace air lter.
Replace the cover on the unit until it latches.
In order to mount the gun more easily apply lubricating grease (enclosed) liberally
to the O-ring at the gun front part (Fig. 14, 19).
17. Spare Parts
Spare Parts List (Fig. 14)
Pos. Name Order No.
1 Union nut 2362 873
2 Air cap 2362 877
3 Nozzle 2362 878
4 Nozzle seal 0417 706
5 Standard spray attachment incl. 800 ml container 2361 730
6 Handle 2362 879
7 Air hose 2333 278
8 Carrying belt 2322 299
9 Cover 2355 072
10 Air lter 2307 279
11 Container with cover 800 ml 0413 909
12 Suction tube 2362 876
13 Container seal 2323 039
14, 15, 16 Ventilating hose, Valve cover, Diaphragm 2304 027
17 Air nozzle 2362 931
18 Stirring rod 2304 419
Lubricating grease 2315 539
To Next Page
Loading...
