WAGNER W 510 - Available Accessories; Troubleshooting Common Issues

GB
30
W 510
19. Accessories
The CLICK&PAINT SYSTEM with additional spray attachments and accessories oers
the right tool for each work.
Further information about the WAGNER range of products for renovating is available
under www.wagner-group.com
20. Correction of Malfunctions
Problem Cause Remedy
No coating material
emerges from the
nozzle
•
Nozzle clogged
•
Feed tube clogged
•
Material volume setting turned
too far to the left (-)
•
Feed tube loose
•
No pressure build-up in container
•
Ventilating bore (Fig. 9,1) clogged
➞ Clean
➞ Clean
➞ Turn to the right (+)
➞ Insert
➞ Tighten container
➞ Clean
Coating material
drips from the
nozzle
•
Nozzle loose
•
Nozzle worn
•
Nozzle seal is missing or worn
•
Coating material assembly at air
cap, nozzle or needle
➞ Tighten
➞ Change
➞ Change
➞ Clean
Atomisation too
coarse
•
Coating material too thick
•
Material volume too large
Material volume adjusting screw
turned too far to the right (+)
•
Nozzle clogged
•
Air lter heavily soiled
•
Too little pressure build-up in
container
➞ Dilute
➞ Turn material volume
adjusting screw to the
left (-)
➞ Clean
➞ Change
➞ Tighten container
Spray jet pulsates
•
Coating material in container
running out
•
Air lter heavily soiled
•
Nozzle seal is missing or worn
➞ Rell
➞ Change
➞ Change
Coating material
causes "paint tears"
•
Too much coating material
applied.
➞ Turn material volume
adjusting screw to the
left (-)
Too much fog of
coating material
(Overspray)
•
Distance to the object too large
•
Too much coating material
applied
➞ Reduce distance
➞ Turn material volume
adjusting screw to the
left (-)