WAGNER W 575 FLEXIO User Manual

21
W 575 Flexio
AUS
20. Accessories
Wagner's unique Click & Paint System means additional spray attachments can be
purchased to suit a variety of dierent projects and surfaces.
Further information about the range of suitable accessories can be found at
www.wagneraustralia.com.au
21. Correction of Malfunctions
Problem Cause Remedy
No coating material
emerges from the
nozzle
•
Device not switched on
•
Nozzle clogged
•
Feed tube clogged
•
Material quantity too small
•
Feed tube loose
•
No pressure build-up in container
•
Ventilating bore (Fig. 11,1)
clogged
➞ Press the ON/OFF switch
on the side of the device
➞ Clean
➞ Clean
➞ Increase the quantity
of material
➞ Insert
➞ Tighten container
➞ Clean
Coating material
drips from the
nozzle
•
Nozzle loose
•
Nozzle worn
•
Nozzle seal is missing or worn
•
Coating material assembly at air
cap, nozzle or needle
➞ Tighten
➞ Change
➞ Change
➞ Clean
Atomisation too
coarse
•
Coating material too thick
•
Material volume too large
•
Nozzle clogged
•
Air cap assembled incorrectly
•
Air lter heavily soiled
•
Too little pressure build-up in
container
•
Amount of air too low
➞ Dilute
➞ Reduce the material
volume
➞ Clean
➞ Snap air cap properly
into place (g. 16, 2)
➞ Change
➞ Tighten container
➞ Increase air quantity
(Level: II)
Spray jet pulsates
•
Coating material in container
running out
•
Air lter heavily soiled
•
Nozzle seal is missing or worn
➞ Rell
➞ Change
➞ Change

WAGNER W 575 FLEXIO Specifications

General

Brand	WAGNER
Model	W 575 FLEXIO
Category	Paint Sprayer
Language	English