WAGNER W 575 FLEXIO - Technical Data

22
W 575 Flexio
AUS
Problem Cause Remedy
Coating material
causes "paint tears"
•
Too much coating material
applied.
➞ Reduce the material
volume
Too much fog of
coating material
(Overspray)
•
Distance to the object too large
•
Too much coating material
applied
•
Amount of air too high
➞ Reduce distance
➞ Reduce the material
volume
➞ Decrease air quantity
(Level: I)
Paint in the
ventilating hose
•
Diaphragm soiled
•
Diaphragm defective
➞ Clean the diaphragm
➞ Replace the diaphragm
Poor covering
capacity on the wall
•
Spray material is too cold
•
Highly absorbent surface or paint
with poor covering capacity
•
Distance too large
➞ The material you are
spraying should be at
room temperature
➞ Cross spray (Fig. 10)
➞ Closer to the object
22. Technical Data
Technical Data
Max. viscosity (Interior wall paint/Wall Extra
I-Spray spray attachment): 4000 mPas
Power source: 240 V
~
, 50 Hz
Power consumption: 630 W
Atomizing output: 100 W (min), 200 W (max)
Max. ow rate (Interior wall paint/Wall Extra
I-Spray spray attachment): 500 ml/min
Protection Class: I
Sound pressure level*: 79 dB (A); Uncertainty K = 4 dB
Sound pressure output*: 90 dB (A); Uncertainty K = 4 dB
Oscillation level*: < 2.5 m/s²; Uncertainty K = 1.5 m/s²
Weight: 1.7 kg
* Measured in accordance with EN 60745-1
Information about the oscillation level
The specied oscillation level has been measured according to a standard test
procedure and can be used to compare against electric tools.
The oscillation level is also for determining an initial assessment of the vibrational
strain.