WAGNER W 590 User Manual

29
W 590 Flexio
EN
14. Adjusting the Material Volume
(Standard spray attachment)
Set the material volume by turning the regulator on the trigger guard of the spray gun.
(Fig. 10)
lower material volume  turn anti-clockwise (-)
higher material volume  turn clockwise (+)
15. Setting the Amount of Air (Fig. 11)
i
Depending on the viscosity of the material to be sprayed and the nish of
the object to be coated, it may be advisable to vary the amount of air. Very
low viscosity materials, such as watery glazes do not have to be atomised
with the maximum amount of air. In this case it is advisable to reduce
the amount of air and thus minimize the spray vapour.
This also applies for the use of the Detail and Corner&Reach spray attachment
(accessory).
Turn the air quantity regulator (g. 11, 1) until the level you want is above the arrow.Turn the air quantity regulator (g. 11, 1) until the level you want is above the arrow.
thin paint thin paint

Level min to 6Level min to 6
thick paint (e.g. interior wall paint)thick paint (e.g. interior wall paint)

Level 6 to maxLevel 6 to max
16. Spray Technique
i
The spray result depends heavily on the smoothness and cleanliness of the
surface to be sprayed. Therefore the surface should be carefully prepared and
kept free of dust.
•
Cover all surfaces not to be sprayed.
•
Cover screw threads or similar parts of the target object.
i
Important: Start at the edge of the area to be sprayed. Start the spray
movement rst of all, and then press the trigger. Avoid interruptions
within the area to be sprayed.
•
The spray movement should come from the arm, not just from the wrist. This ensures that
a uniform distance is maintained between the spray gun and the spray surface during
the spray operation. Select a distance of 5 - 15 cm, depending on the desired spray jet
width. When you are using interior wall paint, the distance should be about 20-30 cm
(approx. one stirring rod in length).
Fig. 12 A/ 12 B: CORRECT Even distance to the object.
Fig. 12 C: INCORRECT An uneven distance will result in uneven paint
application.

WAGNER W 590 Specifications

General

Power	630 W
Max. Viscosity	80 DIN
Power Consumption	630 W
Max. Power Consumption	630 W
Voltage	230 V
Frequency	50 Hz
Container Capacity	1300 ml
Container Volume	1.3 L