WAGNER W 590 User Manual

35
W 590 Flexio
EN
ProblemProblem CauseCause RemedyRemedy
Coating material
drips from the
nozzle
•
Nozzle loose
•
Nozzle worn
•
Nozzle seal is missing or worn
•
Coating material assembly at air
cap, nozzle or needle
•
Tighten
•
Change
•
Change
•
Clean
Atomisation too
coarse
•
Coating material too thick
•
Material volume too large
•
Nozzle clogged
•
Air cap assembled incorrectly
•
Air lter heavily soiled
•
Too little pressure build-up in
container
•
Amount of air too low
•
Dilute
•
Reduce the material
volume
•
Clean
•
Snap air cap properly
into place (g. 19, 2)
•
Change
•
Tighten container
•
Increase air quantity
Spray jet pulsates
•
Coating material in container
running out
•
Air lter heavily soiled
•
Nozzle seal is missing or worn
•
Rell
•
Change
•
Change
Coating material
causes "paint tears"
•
Too much coating material
applied.
•
Reduce the material
volume
Too much fog of
coating material
(Overspray)
•
Distance to the object too large
•
Too much coating material
applied
•
Amount of air too high
•
Reduce distance
•
Reduce the material
volume
•
Decrease air quantity
Paint in the
ventilating hose
•
Diaphragm soiled
•
Diaphragm defective
•
Clean the diaphragm
•
Replace the diaphragm
Poor covering
capacity on the wall
•
Spray material is too cold
•
Highly absorbent surface or paint
with poor covering capacity
•
Distance too large
•
The material you are
spraying should be at
room temperature
•
Cross spray (Fig. 13)
•
Closer to the object

WAGNER W 590 Specifications

General

Power	630 W
Max. Viscosity	80 DIN
Power Consumption	630 W
Max. Power Consumption	630 W
Voltage	230 V
Frequency	50 Hz
Container Capacity	1300 ml
Container Volume	1.3 L