Environmental protection
The appliance and accessories should be recycled in an environmentally
friendly way. Do not dispose of the appliance with household waste. Support
environmental protection by taking the appliance to a local collection point or
obtain information from a specialist retailer.
Important Note regarding Product Liability!
Due to an EC ordinance in eect since 01.01.1990, the manufacturer is liable for his product
only if all parts originate from or were approved by the manufacturer and the devices
are assembled and operated correctly. The use of other accessories and spare parts can
partially or completely invalidate the liability.
Correction of Malfunctions
Problem Cause Remedy
No coating material
emerges from the
nozzle
Nozzle clogged
•
Material volume setting
•
turned too far to the left (-)
No pressure build-up in
•
container
Container empty
•
Feed tube loose
•
Feed tube clogged
•
Clean ➞
Turn to the right (+) ➞
Tighten container ➞
Rell ➞
Insert ➞
Clean ➞
Coating material
drips from the
nozzle
Coating material assembly
•
at air cap, nozzle or needle
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
•
Clean ➞
Union nut tighten ➞
Change ➞
Change ➞
Atomisation too
coarse
Material volume too large
•
Material volume adjusting
•
screw turned too far to the
right (+)
Nozzle contaminated
•
Viscosity of coating material
•
too high
Too little pressure build-up
•
in container
Air lter heavily soiled
•
Turn material volume ➞
adjusting screw to the
left (-)
Clean ➞
Dilute further ➞
Tighten container ➞
Change ➞
Spray jet pulsates Coating material in
•
container running out
Nozzle seal worn
•
Air lter heavily soiled
•
Rell ➞
Replace ➞
Change ➞
To Next Page
Loading...
Need help?
General
